Category: Prusa MK3
Is SLA in my future?
Until I have a need for higher resolution I am not going to mess with resins.
Minions for test prints
I like using Minions as my MMU test prints. Their story is that there are thousands of them. they look alike but each one is slightly different. That means as a finished product “Imperfection is acceptable!”
Coaster Maker in FreeCAD
Looking for something that is Multiple Material, can be customized, and is useful? Try the FloatingCAM CoasterMaker.
Wall Peg with Bearing
A wall mount for spools that use the bearings and aluminum tubes from the MMU tray it replaced. I created this for my Wall Mount…
Multiple Material 2S is here!
I am anxiously awaiting the Multiple Material 2S upgrades promised by Prusa. During my wait I have printed the MK3S extruder and even ordered and…
Core-XY with Cyclops and Chimera
To date my only experience in 3D printing has been with the Prusa i3 design. With that in mind I wanted to make my next…
Up and Printing with my new Prusa MK3
After a couple of days printing with the MK3 I’ve had more success than months with my A8. I’m not complaining because I purchased the…
First Print-off — MK3 Wins Hands down!!!
Last night I set out to work with Polycarbonite (PC) and it didn’t go well, at least at first. It ended in a print-off with…
Prusa MK3 – Pi Zero W (NOT)
With my Prusa MK3 up and running I was ready to install the Pi-Zero W I had prepared. I didn’t want the Zero installed until…